Description
Qual Craft Shingle Shark
The Qualcraft shingle shark is designed to allow for accurate and repeatable cuts at any angle, as well as lengthwise cuts for a starter course used along the edge of the roof. It has two offset holes, one for America and one for US shingles. The crosscut guide adjusts a full 180 degrees for any angle, cuts face up or face down and from either the top or bottom edge. It can be set up by using a cleat to prevent slippage, using a piece of two-by-ten lumber and footing the tool against it, or by using a 6 In. x 90-degree roof bracket.
Features
Cuts both asphalt or fiberglass shingles at any angle
Cold rolled steel construction with powder coat paint finish
Self cleaning arm
Open mesh table allows the weight of the unit to be 38 Lb.
Reviews
There are no reviews yet.